Canon imageCLASS MF7470 - Manual (Page 56)

1
2
3
4
5
6
7
8
9
10
11
2-8
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
If you are placing the original on the platen glass, the size of the
original is detected after the feeder is closed. Make sure to close
the feeder before scanning.
Open the feeder and remove the original from the platen glass
when scanning is complete.
The machine cannot detect the size of STMT and STMTR originals
that are placed on the platen glass. After pressing (Start),
follow the instructions on the screen to specify the original size.
You can also manually select the paper size.
–
–
–
Into the Feeder
If the same original is fed through the feeder repeatedly, the
original may fold or become creased, and make feeding
impossible. Limit repeated feeding to a maximum of 30 times
(this number varies, depending on the type and quality of the
original).
If the feeder rollers are dirty from scanning originals written in
pencil, perform the feeder cleaning procedure. (See “Cleaning the
Machine,” on p. 9-2.)
Always smooth out any folds in your originals before placing
them into the feeder.
Set the originals one by one if they are very thin (10 to 16 lb (37
to 52 g/m
2 )) or very thick (28 to 32 lb bond (105 to 128 g/m 2 )).
11" x 17" and LGL originals must be placed horizontally in the
feeder.
1. Adjust the slide guides to fit the size of your
originals.
■
–
–
–
–
–