Canon imageCLASS MF7470 - Manual (Page 209)

1
2
3
4
5
6
7
8
9
10
11
6-8
Previous Back Next
TOP
Before Using the
Machine
Original and Paper
Copying
Sending and
Receiving
Printing and
Scanning
Network (imageCLASS
MF7480/MF7470 Only)
Remote UI (imageCLASS
MF7480/MF7470 Only)
System Settings
Maintenance
Troubleshooting
Appendix
Index
Table of Contents
Setting Up a Computer for Printing/Sending a Fax
This section describes procedures for Setting Up a computer for
printing/sending a fax.
Before setting up a computer for printing/sending a fax, it is
necessary to perform the setup procedures described in “Basic
Network Settings,” on p. 6-5.
It is recommended that the network administrator perform the following
procedures.
Setting Printing Method
You can select the printing method over a TCP/IP network.
1. Press (Additional Functions).
2.
Press [System Settings] → [Network Settings] →
[TCP/IP Settings] → [ ▼] → [LPD Settings].
If the System Manager ID and System Password have been set, enter
the System Manager ID and System Password using
– (numeric
keys), then press (Log In/Out) to enter the System Settings menu.
The LPD Settings screen appears.
3. Select [On] or [Off].
[On]: Uses LPD as the print application.
[Off ]: Does not use LPD as the print application.
4. Press [OK].
5. Press [RAW Settings].
■
6. Select [On] or [Off].
[On]: Uses Raw as the print application. Proceed to step 7.
[Off ]: Does not use Raw as the print application. Skip to step 8.
7. Select [On] or [Off] for .
[On]: Establishes bidirectional communication using Port 9100.
[Off ]: Does not establish bidirectional communication using Port
9100.
8. Press [OK].
9. Press [Done] repeatedly until the Additional
Functions screen closes.
10. Restart the machine.
Turn off the machine, wait at least 10 seconds, then turn it on.