3Com WXR100 3CRWXR10095A - Manual (Page 85)

2 A
CCESS
C
OMMANDS
This chapter describes access commands used to control access to the
Mobility Software System (MSS) command-line interface (CLI).
Commands by
Usage This chapter presents access services commands alphabetically. Use
Table 6 to located commands in this chapter based on their use.
disable Changes the CLI session from enabled mode to restricted access.
Syntax —
disable
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command restricts access to the CLI for the
current session:
WX1200# disable
WX1200>
See Also
„
enable on page 86
Table 6 Access Commands by Usage
Type Command
Access Privileges enable on page 86
set enablepass on page 87
disable on page 85
quit on page 86