3Com WXR100 3CRWXR10095A - Manual (Page 432)

432 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Defaults — All radios use the internal antenna by default, if the MAP
model has an internal antenna. The AP 3150 802.11b/g radio uses model
ANT1060 by default.)
Access — Enabled.
History — Introduced in MSS Version 3.0. Model numbers added for
802.11a external antennas, and the default changed to internal (except
for the AP3150) in MSS Version 3.2.
Examples — The following command configures the 802.11b/g radio on
Distributed MAP 1 to use antenna model ANT1060:
WX4400# set ap 1 radio 1 antennatype ANT1060
success: change accepted.
See Also
„
display ap config on page 364
set ap radio
auto-tune
max-power Sets the maximum power that RF Auto-Tuning can set on a radio.
Syntax — set {ap ap-number auto} radio {1 | 2} auto-tune
max-power power-level
„ ap ap-number
— Index value that identifies the MAP on the WX.
„ ap auto
— Sets the maximum power for radios configured by the
MAP configuration profile. (See set ap auto on page 410.)
„ radio 1
— Radio 1 of the MAP.
„ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„ power-level
— Maximum power setting RF Auto-Tuning can assign
to the radio, expressed as the number of decibels in relation to 1
milliwatt (dBm). You can specify a value from 1 up to the maximum
value allowed for the country of operation.
The power-level can be a value from 1 to 20.