3Com WXR100 3CRWXR10095A - Manual (Page 437)

set ap radio load balancing 437
Usage — A Mesh Portal MAP can be configured to emit link calibration
packets to assist with positioning the Mesh AP. A link calibration packet is
an unencrypted 802.11 management packet of type Action. When
enabled on an MAP, link calibration packets are sent at a rate of 5 per
second.
Only one radio on an MAP can be configured to send link calibration
packets. Link calibration packets are intended to be used only during
installation of MAPs; they are not intended to be enabled on a continual
basis.
Examples — The following command enables link calibration packets for
MAP radio 1 on MAP 7 :
WX# set ap 7 radio 1 link-calibration mode enable
WX#
See Also
„
display ap mesh-links on page 377
„
set ap boot-configuration mesh ssid on page 421
„
set service-profile mesh on page 498
set ap radio load
balancing Disables or enables RF load balancing for an MAP radio.
Syntax — set ap ap-number radio {1 | 2} load balancing {enable
| disable}
„ ap ap-number — Index value that indentifies the MAP on the WX.
„ radio 1 — Radio 1 of the MAP.
„ radio 2
— Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„ enable — Enables link calibration packets for the MAP radio.
„ disable
— Disables link calibration packets for the MAP radio.
Defaults — Disabled.
Access — Enabled.
History — Introduced in MSS Version 6.0.