3Com WXR100 3CRWXR10095A - Manual (Page 445)

set band-preference 445
set band-preference Configures MSS to steer clients that support both the 802.11a and
802.11b/g radio bands to a specific radio on an MAP for the purpose of
RF load balancing.
Syntax —
set band-preference {none | 11bg | 11a}
„ none
— When a client supports both 802.11a and 802.11b/g radio
bands, does not steer the client to a specific MAP radio.
„ enable
— When a client supports both 802.11a and 802.11b/g radio
bands, steers the client to the 802.11b/g radio.
„ disable — When a client supports both 802.11a and 802.11b/g
radio bands, steers the client to the 802.11a radio.
Defaults — By default, clients are not steered to specific MAP radios for
RF load balancing.
Access — Enabled.
History — Introduced in MSS Version 6.0.
Usage — Use this command to steer clients that support both the
802.11a and 802.11b/g bands, to a specific radio on an MAP for the
purpose of load balancing. This global band-preference option controls
the degree that an MAP with two radios attempts to conceal one of its
radios from a client with the purpose of steering the client to the other
radio.
Examples — The following command steers clients that support both
the 802.11a and 802.11b/g bands to the 802.11a radio on an MAP:
WX# set band-preference 11a
WX#
See Also
„
display load-balancing group on page 396
„
set load-balancing mode on page 446
„
set load-balancing strictness on page 447
„
set ap radio load balancing on page 437