3Com WXR100 3CRWXR10095A - Manual (Page 342)

342 C HAPTER 10: N ETWORK D OMAIN C OMMANDS
clear
network-domain
peer Removes the configuration of a Network Domain peer from a WX
configured as a Network Domain seed.
Syntax — clear network-domain peer { ip-addr | all}
„ ip-addr
— IP address of the Network Domain peer in dotted decimal
notation.
„ all
— Clears the Network Domain peer configuration for all peers
from the WX switch.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — This command has no effect if the WX is not configured as a
Network Domain seed.
Examples — The following command clears the Network Domain peer
configuration for peer 192.168.9.254 from the WX:
WX1200# clear network-domain peer 192.168.9.254
success: change accepted.
The following command clears the Network Domain peer configuration
for all peers from the WX:
WX1200# clear network-domain peer all
success: change accepted.
See Also
„
set network-domain peer on page 347