Set igmp lmqi – 3Com WXR100 3CRWXR10095A User Manual
Page 574
574
C
HAPTER
13: IGMP S
NOOPING
C
OMMANDS
set igmp lmqi
Changes the IGMP last member query interval timer on one VLAN or all
VLANs on a wireless LAN switch.
Syntax —
set igmp lmqi
tenth-seconds [vlan vlan-id]
lmqi
tenth-seconds
— Amount of time (in tenths of a second) that
the WX waits for a response to a group-specific query after receiving a
leave message for that group, before removing the receiver that sent
the leave message from the list of receivers for the group. If there are
no more receivers for the group, the WX switch also sends a leave
message for the group to multicast routers. You can specify a value
from 1 through 65,535.
vlan
vlan-id
— VLAN name or number. If you do not specify a
VLAN, the timer change applies to all VLANs.
Defaults — The default last member query interval is 10 tenths of a
second (1 second).
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command changes the last member query
interval on VLAN orange to 5 tenths of a second:
WX1200# set igmp lmqi 5 vlan orange
success: change accepted.
See Also