3Com WXR100 3CRWXR10095A - Manual (Page 328)

328 C HAPTER 9: M OBILITY D OMAIN C OMMANDS
clear
mobility-domain Clears all Mobility Domain configuration and information from a WX ,
regardless of whether the WX is a seed or a member of a Mobility
Domain.
Syntax —
clear mobility-domain
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command has no effect if the WX is not configured as part
of a Mobility Domain.
Examples — To clear a Mobility Domain from a WX within the domain,
type the following command:
WX1200# clear mobility-domain
success: change accepted.
See Also
„
clear mobility-domain member on page 328
„
set mobility-domain member on page 332
„
set mobility-domain mode member seed-ip on page 334
„
set mobility-domain mode seed domain-name on page 336
clear
mobility-domain
member On the seed WX, removes the identified member from the Mobility
Domain.
Syntax — clear mobility-domain member ip-addr
„ ip-addr — IP address of the Mobility Domain member, in dotted
decimal notation.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.