3Com WXR100 3CRWXR10095A - Manual (Page 770)

770 C HAPTER 24: B OOT P ROMPT C OMMANDS
autoboot Displays or changes the state of the autoboot option. The autoboot
option controls whether a WX switch automatically boots a system image
after initializing the hardware, following a system reset or power cycle.
Syntax — autoboot [ON | on | OFF | off]
„ ON — Enables the autoboot option.
„ on
— Same effect as
ON
.
„ OFF
— Disables the autoboot option.
„ off — Same effect as OFF .
Defaults — The autoboot option is enabled by default.
Access — Boot prompt.
History —Introduced in MSS Version 3.0.
Examples — The following command displays the current setting of the
autoboot option:
boot> autoboot
The autoboot flag is on.
See Also
„
boot on page 771
Boot Profile Management display on page 778
create on page 774
Boot Profile
Management, cont. next on page 783
change on page 773
delete on page 775
Diagnostics diag on page 777
test on page 785
Table 121 Boot Prompt Commands by Usage (continued)
Type Command