3Com WXR100 3CRWXR10095A - Manual (Page 641)

17 802.1X M
ANAGEMENT
C
OMMANDS
Use 802. IEEE X management commands to modify the default settings
for IEEE 802.1X sessions on an WX. For best results, change the settings
only if you are aware of a problem with 802.1X performance on the WX.
CAUTION: 802.1X parameter settings are global for all SSIDs configured
on the switch.
Commands by
Usage This chapter presents 802.1X commands alphabetically. Use Table 93 to
locate commands in this chapter based on their use. For information
about configuring 802.1X commands for user authentication, see “AAA
Commands” on page 259.
Table 93 802.1X Commands by Usage
Type Command
Wired Authentication Port
Control set dot1x port-control on page 654
clear dot1x port-control on page 643
set dot1x authcontrol on page 650
Keys set dot1x key-tx on page 652
set dot1x tx-period on page 658
clear dot1x tx-period on page 647
set dot1x wep-rekey on page 659
set dot1x wep-rekey-period on page 660
Bonded Authentication clear dot1x bonded-period on page 642
set dot1x bonded-period on page 651
Reauthentication set dot1x reauth on page 655
set dot1x reauth-max on page 656
Reauthentication, cont. clear dot1x reauth-max on page 645