3Com WXR100 3CRWXR10095A - Manual (Page 699)

display rfdetect visible 699
Usage — If a 3Com radio is supporting more than one SSID, each of the
corresponding BSSIDs is listed separately.
To display rogue information for the entire Mobility Domain, use the
display rfdetect mobility-domain command on the seed switch.
Examples — The following command displays the devices detected by
3Com radio 00:0b:0e:00:0a:6a:
WX1200# display rfdetect visible 00:0b:0e:00:0a:6a ap 3 radio 1
Total number of entries: 104
Flags: i = infrastructure, a = ad-hoc
c = CCMP, t = TKIP, 1 = 104-bit WEP, 4 = 40-bit WEP, w = WEP(non-WPA)
Transmit MAC Vendor Type Ch RSSI Flags SSID
----------------- ------- ----- --- ---- ------ --------------------------------
00:07:50:d5:cc:91 Cisco intfr 6 -60 i----w r27-cisco1200-2
00:07:50:d5:dc:78 Cisco intfr 6 -82 i----w r116-cisco1200-2
00:09:b7:7b:8a:54 Cisco intfr 2 -54 i-----
00:0a:5e:4b:4a:c0 3Com intfr 11 -57 i----- public
00:0a:5e:4b:4a:c2 3Com intfr 11 -86 i-t1-- 3Comwlan
00:0a:5e:4b:4a:c4 3Com intfr 11 -85 ic---- 3com-ccmp
00:0a:5e:4b:4a:c6 3Com intfr 11 -85 i-t--- 3com-tkip
00:0a:5e:4b:4a:c8 3Com intfr 11 -83 i----w 3com-voip
00:0a:5e:4b:4a:ca 3Com intfr 11 -85 i----- 3com-webaaa
...
Table 110 describes the fields in this display.
Table 110 display rfdetect visible Output
Field Description
Transmit MAC MAC address the rogue device that sent the 802.11 packet
detected by the MAP radio.
Vendor Company that manufactures or sells the rogue device.
Type Classification of the rogue device:
„
rogue—Wireless device that is on the network but is not
supposed to be on the network.
„ intfr—Wireless device that is not part of your network and
is not a rogue, but might be causing RF interference with
MAP radios.
„
known—Device that is a legitimate member of the
network.
Ch Channel number on which the radio detected the rogue.