3Com WXR100 3CRWXR10095A - Manual (Page 229)

set ip ssh server 229
See Also
„
set ip ssh server on page 229
set ip ssh server Disables or reenables the SSH server on a WX.
CAUTION: If you disable the SSH server, SSH access to the WX is also
disabled.
Syntax — set ip ssh server {enable | disable}
„ enable
— Enables the SSH server.
„ disable — Disables the SSH server.
Defaults — The SSH server is enabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must generate an SSH authentication key to use SSH.
The maximum number of SSH sessions supported on a WX is eight. If
Telnet is also enabled, the WX can have up to eight Telnet or SSH
sessions, in any combination, and one Console session.
See Also
„
crypto generate key on page 613
„
set ip ssh on page 228
„
set ip ssh server on page 229
set ip telnet Changes the TCP port number on which a WX listens for Telnet
management traffic.
CAUTION: If you change the Telnet port number from a Telnet session,
MSS immediately ends the session. To open a new management session,
you must Telnet to the WX with the new Telnet port number.
Syntax — set ip telnet port-num
„ port-num
— TCP port number.