3Com WXR100 3CRWXR10095A - Manual (Page 31)

AP 3950 PoE Configuration 31
Syntax — set cluster preempt {enable | disable}
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 7.0.
Usage — You can only use this command on the secondary seed of the
mobility domain.
Examples — The following command enables preempt mode on a
secondary seed:
WX# set cluster preempt enable
success:change accepted
AP 3950 PoE
Configuration A new command supports PoE configuration on the AP 3950.
set ap power-mode Syntax — set ap apnum power-mode {auto | high}
„ auto
— Power is managed automatically by sensing the power level
on the AP. If low power is detected, unused Ethernet is disabled and
reduces the traffic on the 2.4 GHz radio. If high power is detected,
then both radios operate at 3x3 (3 transmit chains and 3 receive
chains).
„ high — Both radios operate at the maximum power available, which
requires either 802.3at PoE or both ports using 802.3af PoE.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 7.0.
802.11n
Configuration These commands support configuration of 802.11n frame aggregation,
data rates, and channel width on the AP 3950.