3Com WXR100 3CRWXR10095A - Manual (Page 355)

clear ap local-switching vlan-profile 355
clear ap
local-switching
vlan-profile Clears the VLAN profile that had been applied to an MAP to use with
local switching.
Syntax — clear {ap ap-number local-switching vlan-profile
„ ap-number — Index value that identifies the MAP on the WX switch.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 6.0.
History — A VLAN profile consists of a list of VLANs and tags. When a
VLAN profile is applied to a MAP, traffic for the VLANs specified in the
VLAN profile is locally switched by the MAP instead of being tunneled
back to a WX. When the VLAN profile is cleared from the MAP, traffic
that had been locally switched is tunneled to a WX.
When clearing a VLAN profile causes traffic that had been locally
switched by MAPs to be tunneled to a WX, the sessions of clients
associated with the MAPs where the VLAN profile is applied are
terminated, and the clients must re-associate with the MAPs.
Examples — The following command clears the VLAN profile that had
been applied to MAP 7:
WX# clear ap 7 local-switching vlan-profile
success: change accepted.
See Also
„
set vlan profile on page 175
„
set ap local-switching mode on page 427
„
set ap local-switching vlan-profile on page 428