3Com WXR100 3CRWXR10095A - Manual (Page 471)

set radio-profile rts-threshold 471
See Also
„
display ap counters on page 367
„
set service-profile transmit-rates on page 516
set radio-profile
rts-threshold Changes the RTS threshold for the MAP radios in a radio profile. The RTS
threshold specifies the maximum length a frame can be before the radio
uses the RTS/CTS method to send the frame. The RTS/CTS method clears
the air of other traffic to avoid corruption of the frame due to a collision
with another frame.
Syntax —
set radio-profile name rts-threshold threshold
„ name
— Radio profile name.
„ threshold — Maximum frame length, in bytes. You can enter a value
from 256 through 3000.
Defaults — The default RTS threshold for a MAP radio is 2346 bytes.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.
Examples — The following command changes the RTS threshold for
radio profile rp1 to 1500 bytes:
WX4400# set radio-profile rp1 rts-threshold 1500
success: change accepted.
See Also
„
display radio-profile on page 398
„
set radio-profile mode on page 464