3Com WXR100 3CRWXR10095A - Manual (Page 414)

414 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
set ap auto mode Enables a WX profile for automatic Distributed MAP configuration.
Syntax —
set ap auto mode {enable | disable}
„ enable — Enables the MAP configuration profile.
„ disable — Disables the MAP configuration profile.
Defaults — The MAP configuration profile is disabled by default.
Access — Enabled.
History —Introduced in MSS 4.0. Version 6.0 removed the dap option.
Usage — You must use the set ap auto command to create the profile
before you can enable it.
Examples — The following command enables the profile for automatic
Distributed MAP configuration:
WX4400# set ap auto mode enable
success: change accepted.
See Also
„
set ap auto on page 410
„
set ap auto persistent on page 412
„
set ap auto radiotype on page 413
„
set ap bias on page 415
„
set ap blink on page 416
„
set ap group on page 427
„
set ap radio auto-tune max-power on page 432
„
set ap radio auto-tune max- retransmissions on page 433
„
set ap radio link-calibration on page 436
„
set ap radio mode on page 439
„
set ap radio radio-profile on page 440
„
set ap upgrade-firmware on page 444