3Com WXR100 3CRWXR10095A - Manual (Page 235)

set snmp notify profile 235
See Also
„
clear snmp community on page 191
„
set ip snmp server on page 228
„
set snmp notify target on page 240
„
set snmp notify profile on page 235
„
set snmp protocol on page 245
„
set snmp security on page 246
„
set snmp usm on page 247
„
display snmp community on page 209
set snmp notify
profile Configures an SNMP notification profile. A notification profile is a named
list of all the notification types that can be generated by a switch, and for
each notification type, the action to take (drop or send) when an event
occurs.
You can configure up to ten notification profiles.
Syntax —
set snmp notify profile {default | profile-name}
{drop | send} {notification-type | all}
„ default | profile-name
— Name of the notification profile you are
creating or modifying. The profile-name can be up to 32 alphanumeric
characters long, with no spaces. To modify the default notification
profile, specify default.
„ drop | send
— Specifies the action that the SNMP engine takes with
regard to the notifications you specify with notification-type or all.
„ notification-type — Name of the notification type:
„
APBootTraps—Generated when a MAP access point boots.
„
ApNonOperStatusTraps—Generated to indicate a MAP radio is
nonoperational.
„
ApOperRadioStatusTraps—Generated when the status of a
MAP radio changes.
„
APRejectLicenseExceededTraps—Generated when a WX switch
receives a packet from an inactive AP and attaching that AP would
make the WX switch exceed the maximum (licensed) number of
active APs.