3Com WXR100 3CRWXR10095A - Manual (Page 476)

476 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must configure the service profile before you can map it to
a radio profile. You can map the same service profile to more than one
radio profile.
You must disable all radios that use a radio profile before you can change
parameters in the profile. Use the set radio-profile mode command.
Examples — The following command maps service-profile wpa_clients
to radio profile rp2:
WX4400# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
See Also
„
display radio-profile on page 398
„
display service-profile on page 401
„
set service-profile attr on page 479
„
set service-profile auth-dot1x on page 481
„
set service-profile auth-fallthru on page 482
„
set service-profile auth-psk on page 483
„
set service-profile beacon on page 484
wep key-index No keys
defined Uses dynamic WEP rather than static WEP.
If you configure a WEP key for static WEP,
MSS continues to also support dynamic
WEP.
wep active-
multicast-index 1 Uses WEP key 1 for static WEP encryption
of multicast traffic if WEP encryption is
enabled and keys are defined.
wep active-unicast-
index 1 Uses WEP key 1 for static WEP encryption
of unicast traffic if WEP encryption is
enabled and keys are defined.
wpa-ie disable Does not use the WPA IE in transmitted
frames.
Table 74 Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set
to Default Value