3Com WXR100 3CRWXR10095A - Manual (Page 430)

430 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
set ap radio
antenna-location Specifies the location (indoors or outdoors) of an external antenna. Use
this command to ensure that the proper set of channels is available on
the radio. In some cases, the set of valid channels for a radio differs
depending on the location of the antenna, indoors or outdoors.
Syntax — set ap apnum radio number antenna-location
{indoors | outdoors}
„ ap apnum —Index value that identifies the MAP on the WX.
„ radio number —Specify radio 1 or radio 2.
„ antenna-location
—Specify antenna location.
„ indoors —Specifies that the external antenna is installed indoors
(inside the building).
„ outdoors
—Specifies that the external antenna is installed outdoors.
Defaults — The default antenna location is indoors.
Access — Enabled.
History —Introduced in MSS 5.0.
Examples — The following command sets the antenna location for radio
1 on Distributed MAP 22 to outdoors:
WX2200# set ap 22 radio 1 antenna-location outdoors
success: change accepted.
See Also
„
set ap radio antennatype on page 431