3Com WXR100 3CRWXR10095A - Manual (Page 127)

display port status 127
See Also
„
set port poe on page 142
display port status Displays configuration and status information for ports.
Syntax —
display port status [port-list]
„ port-list
— List of physical ports. If you do not specify a port list,
information is displayed for all ports.
Defaults — None.
Access — All.
History — Introduced in MSS Version 3.0.
Link status Link status of the port:
„
up—The port is connected.
„ down—The port is not connected.
Port type Port type:
„
MAP —The port is a MAP access port.
„ - (The port is not a MAP access port.)
PoE config PoE state:
„
enabled
„
disabled
PoE Draw Power draw on the port, in watts.
For 10/100 Ethernet ports on which PoE is disabled,
this field displays off. For gigabit Ethernet ports, this
field displays invalid, because PoE is not supported
on gigabit Ethernet ports.
The value overcurrent indicates a PoE problem such
as a short in the cable.
Table 13 Output for display port poe (continued)
Field Description