3Com WXR100 3CRWXR10095A - Manual (Page 534)

534 C HAPTER 12: STP C OMMANDS
„ vlan vlan-id — VLAN name or number. MSS resets the cost for only
the specified VLAN.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — MSS does not change a port’s cost for VLANs other than the
one(s) you specify.
Examples — The following command resets the STP cost for port 2 in
VLAN sunflower:
WX4400# clear spantree portvlancost 2 vlan sunflower
success: change accepted.
See Also
„
clear spantree portcost on page 532
„
display spantree on page 536
„
display spantree portvlancost on page 542
„
set spantree portcost on page 553
„
set spantree portvlancost on page 556
clear spantree
portvlanpri Resets to the default value the priority of a network port or ports for
selection as part of the path to the STP root bridge, on one VLAN or all
VLANs.
Syntax — clear spantree portvlanpri port-list {all | vlan
vlan-id}
„ port-list — List of ports. The port priority is reset to 32 (the default)
on the specified ports.
„ all — Resets the priority for all VLANs.
„ vlan vlan-id — VLAN name or number. MSS resets the priority for
only the specified VLAN.
Defaults — None.
Access — Enabled.