3Com WXR100 3CRWXR10095A - Manual (Page 408)

408 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
See Also
„
set service-profile auth-dot1x on page 481
„
set service-profile auth-fallthru on page 482
„
set service-profile auth-psk on page 483
„
set service-profile auth-psk on page 483
„
set service-profile beacon on page 484
„
set service-profile cac-mode on page 486
„
set service-profile cac-session on page 487
„
set service-profile cipher-ccmp on page 488
„
set service-profile cipher-tkip on page 489
„
set service-profile cipher-wep104 on page 490
„
set service-profile cipher-wep40 on page 491
„
set service-profile cos on page 492
„
set service-profile dhcp-restrict on page 493
„
set service-profile idle-client-probing on page 494
„
set service-profile long-retry-count on page 497
11a / 11b / 11g
transmit rate fields Data transmission rate settings for each radio type:
„
beacon rate—Data rate of beacon frames sent by MAP
radios.
„
multicast rate—Data rate of multicast frames sent by
MAP radios. If the rate is auto, the MAP sets the multicast
rate to the highest rate that can reach all clients
connected to the radio.
„
mandatory rates—Set of data transmission rates that
clients are required to support in order to associate with
an SSID on a MAP radio. A client must support at least
one of the mandatory rates.
„
standard rates—The set of valid rates that are neither
mandatory nor disabled. These rates are supported for
data transmission from the MAP radios.
„
disabled rates—Data transmission rates that MAP radios
will not use to transmit data. (The radios will still accept
frames from clients at disabled data rates.)
Table 71 Output for display service-profile (continued)
Field Description