3Com WXR100 3CRWXR10095A - Manual (Page 189)

clear ip telnet 189
clear ip telnet Resets the Telnet server TCP port number to its default value. A WX
listens for Telnet management traffic on the Telnet server port.
Syntax — clear ip telnet
Defaults — The default Telnet port number is 23.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command resets the TCP port number for
Telnet management traffic to its default:
WX4400# clear ip telnet
success: change accepted.
See Also
„
display ip https on page 203
„
display ip telnet on page 206
„
set ip https server on page 225
„
set ip telnet on page 229
„
set ip telnet server on page 230
clear ntp server Removes an NTP server from a WX configuration.
Syntax — clear ntp server {ip-addr | all}
„ ip-addr
— IP address of the server to remove, in dotted decimal
notation.
„ all
— Removes all NTP servers from the configuration.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.