Set ap group, Set ap location, Set ap local-switching mode – 3Com WXR100 3CRWXR10095A User Manual
Page 427
set ap group
427
set ap group
Deprecated in MSS Version 6.0. To configure RF load balancing, see “set
load-balancing mode” on page 446.
set ap location
Specifies information about the physical location of a MAP.
Syntax —
set ap
port-list location string
Examples — The following command specifies the location of MAP 7 as
the conference room:
WX4400# set ap 7 location ‘the conference room’
success: change accepted.
See Also
set ap
local-switching
mode
Enables local switching for a specified MAP.
Syntax —
set ap
ap-number local-switching mode {enable |
disable
}]
ap-number
— Index value that identifies the MAP on the WX.
mode
{
enable
|
disable
} — Enables or disables local switching for the
MAP.
Defaults
—
Local switching is disabled by default.
Access
—
Enabled.
History
—
Introduced in MSS Version 6.0.
Usage
—
Local switching allows traffic for specified VLANs to be
switched by the
MAP itself, instead of being tunneled back to a WX. The
VLANs for which local switching is performed are specified in a VLAN
profile.
Local switching can be enabled on MSPs that are connected to the WX
via an intermediate Layer 2 or Layer 3 network. Local switching is not
supported for MAPs that are directly connected to an WX.