3Com WXR100 3CRWXR10095A - Manual (Page 340)

340 C HAPTER 10: N ETWORK D OMAIN C OMMANDS
clear
network-domain Clears all Network Domain configuration and information from a WX ,
regardless of whether the WX is a seed or a member of a Network
Domain.
Syntax — clear network-domain
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Examples — This command has no effect if the WX is not configured as
part of a Network Domain.
To clear a Network Domain from a WX within the domain, type the
following command:
WX1200# clear network-domain
This will clear all network-domain configuration. Would you
like to continue? (y/n) [n] y
success: change accepted.
See Also
„
set network-domain mode member seed-ip on page 346
„
set network-domain peer on page 347
„
set network-domain mode seed domain-name on page 348
clear network-domain peer on page 342
clear network-domain seed-ip on page 343
display network-domain on page 344
Table 49 Network Domain Commands by Usage (continued)
Type Command