3Com WXR100 3CRWXR10095A - Manual (Page 45)

RF Detection Configuration 45
Replaced Commands The following table lists pre-MSS 7.0 commands that are now obsolete
and their MSS 7.0 replacements:
Parameters:
„ transmit-mac or mac-addr — Basic service set identifier (BSSID), i.e.
a MAC address, of the device in the neighbor list.
„ OUI — Vendor device ID.
„ all — All devices in the neighbor list.
set rfdetect ssid-list This command has been modified to allow a wildcard for SSID names.
Only the changes are shown below:
Syntax —
set rfdetect ssid-list [ ssid-name | ssid*]
„ ssid-name
— SSID name you want to add to the permitted SSID list.
„ ssid* — SSID glob at add to the permitted SSID list.
set rfdetect
classification ad-hoc
New command used to classify devices as ad-hoc devices on the network.
Syntax —
set rfdetect classification ad-hoc [rogue |
skip-test]
„ rogue — Detects ad-hoc networks and classifies them as rogues.
„ skip-test
— Omit looking for ad-hoc networks and go to the next
classification step.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 6.2.
Table 3 RF Detection Commands Replaced in MSS 7.0
Old Command Group Equivalent Replacement Commands
set rfdetect ignore transmit-mac
display rfdetect ignore
clear rfdetect ignore
set rfdetect neighbor-list [ transmit-mac | oui]
display rfdetect neighbor-list
clear rfdetect neighbor-list [
transmit-mac | oui |
all]
set rfdetect attack-list mac
display rfdetect attack-list
clear rfdetect attack-list
set rfdetect rogue-list mac-addr
display rfdetect rogue-list
clear rfdetect rogue-list [
mac-addr | all]