3Com WXR100 3CRWXR10095A User Manual
Page 249
set snmp usm
249
Defaults — No SNMPv3 users are configured by default. When you
configure an SNMPv3 user, the default access is read-only, and the
default authentication and encryption types are both none.
Access — Enabled.
History — Introduced in MSS Version 4.0.
Examples — The following command creates USM user snmpmgr1,
associated with the local SNMP engine ID. This user can send traps to
notification receivers.
WX#1200 set snmp usm snmpmgr1 snmp-engine-id local
success: change accepted.
The following command creates USM user securesnmpmgr1, which uses
SHA authentication and 3DES encryption with passphrases. This user can
send informs to the notification receiver that has engine ID 192.168.40.2.
WX4400# set snmp usm securesnmpmgr1 snmp-engine-id ip
192.168.40.2 auth-type sha auth-pass-phrase myauthpword
encrypt-type 3des encrypt-pass-phrase mycryptpword
success: change accepted.
See Also
set ip snmp server on page 228
set snmp community on page 233
set snmp notify target on page 240
set snmp notify profile on page 235