3Com WXR100 3CRWXR10095A - Manual (Page 412)

412 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
„
set ap blink on page 416
„
set ap group on page 427
„
set ap radio auto-tune max-power on page 432
„
set ap radio auto-tune max- retransmissions on page 433
„
set ap radio link-calibration on page 436
„
set ap radio mode on page 439
„
set ap radio radio-profile on page 440
„
set ap upgrade-firmware on page 444
set ap auto
persistent Converts a temporary MAP configuration created by the MAP
configuration profile into a persistent MAP configuration on the WX.
Syntax —
set ap auto persistent
[ap-number |
all
]
„ ap-number — Index value that identifies the MAP on the WX.
„ all — Converts the configurations of all Auto-APs being managed by
the switch into permanent configurations.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.0. Version 6.0 removed the dap option.
Usage — To display the Distributed MAP numbers assigned to
Auto-MAPs, use the display ap status auto command.
Examples — The following command converts the configuration of
Auto-AP 10 into a permanent configuration:
WX4400# set ap auto persistent 10
success: change accepted.
See Also
„
set ap auto on page 410
„
set ap auto mode on page 414
„
set ap auto radiotype on page 413