3Com WXR100 3CRWXR10095A - Manual (Page 381)

display ap status 381
The following command uses the terse option to display brief
information for
MAPs:
WX# display ap status terse
Total number of entries: 120
Operational: 1, Image Downloading: 0, Unknown: 119, Other: 0
Flags: o = operational, b = booting, d = image downloading
c = configuring, f = configuration failed
a = auto AP, m = mesh AP, p = mesh portal
i = insecure, e = encrypted, u = unencrypt
AP Flag IP Address Model MAC Address Radio1 Radio2 Uptime
--- ---- --------------- --------- ----------------- ------ ------ ------
7 o--u AP3750 00:0b:0e:00:ca:c0 D11/1 D44/1 21d00h
Table 60 and Table 61 describe the fields in this display.
Table 60 Output for display ap status
Field Description
AP Connection ID for the Distributed MAP.
Note: This field is applicable only if the MAP is configured on
the WX switch as a Distributed MAP.
Port WX port number.
Note: This field is applicable only if the MAP is directly
connected to the WX switch and the WX switch port is
configured as a MAP access port.
IP-addr IP address of the MAP. The address is assigned to the MAP
by a DHCP server.
Note: This field is applicable only if the MAP is not directly
attached to the WX switch.
AP model MAP access point model number.
manufacturer Company that made the MAP access point.
fingerprint Hexadecimal fingerprint of the MAP’s public encryption key.
Note: This field is displayed only if the MAP is not directly
attached to the WX switch.
name MAP access point name.
Link Status of this link with the MAP access point and the MAP
port at the other end of the link. The status can be up or
down.
MAP port MAP port number connected to this WX port.