3Com WXR100 3CRWXR10095A - Manual (Page 438)

438 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Usage — By default, RF load balancing is enabled on all MAP radios.
Use this command to disable or re-enable RF load balancing for the
specified MAP radio.
RF load balancing can also be disabled or re-enabled globally with the set
load-balancing mode command. If RF load balancing has been enabled
or disabled for a specific MAP radio, then the setting for the individual
radio takes precedence over the global setting.
Examples — The following command disables RF load balancing for
MAP radio 1 on MAP 7:
WX# set ap 7 radio 1 load-balancing disable
WX#
See Also
„
set load-balancing strictness on page 447
„
clear ap radio load-balancing group on page 359
„
set ap local-switching mode on page 427
„
display load-balancing group on page 396
set ap radio load
balancing group Assigns an MAP radio to a load balancing group.
Syntax — set ap ap-number radio {1 | 2} load-balancing group
name [rebalance]
„ ap ap-number
— Index value that indentifies the MAP on the WX.
„ radio 1 — Radio 1 of the MAP.
„ radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
„ group name — Name of an RF load balancing group to which the
MAP radio is assigned. A radio can belong to only one group.
„ rebalance — Configures the MAP radio to disassociate its client
sessions and rebalance them whenever a new MAP radio is added to
the load balancing group.
Defaults — By default, MAP radios are not part of an RF load balancing
group.