3Com WXR100 3CRWXR10095A - Manual (Page 714)

714 C HAPTER 20: F ILE M ANAGEMENT C OMMANDS
clear boot
backup-configuration Clears the filename specified as the backup configuration file. In the
event that MSS cannot read the configuration file at boot time, a backup
configuration file is not used.
Syntax —
clear boot backup-configuration
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 4.1.
Examples — The following command clears the name specified as the
backup configuration file from the configuration of the WX switch:
WX4400# clear boot backup-configuration
success: Backup boot config filename was cleared.
See Also
„
display boot on page 722
„
set boot backup-configuration on page 734
clear boot config Resets to the factory default the configuration that MSS loads during a
reboot.
Syntax — clear boot config
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following commands back up the configuration file on
a WX switch, reset the switch to its factory default configuration, and
reboot the switch:
WX4400# copy configuration tftp://10.1.1.1/backupcfg
success: sent 365 bytes in 0.401 seconds [ 910 bytes/sec]
WX4400# clear boot config
success: Reset boot config to factory defaults.