Clear spantree portcost – 3Com WXR100 3CRWXR10095A User Manual
Page 532
532
C
HAPTER
12: STP C
OMMANDS
clear spantree
portcost
Resets to the default value the cost of a network port or ports on paths to
the STP root bridge in all VLANs on a WX.
Syntax —
clear spantree portcost
port-list
port-list
— List of ports. The port cost is reset on the specified ports.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command resets the cost in all VLANs. To reset the cost for
only specific VLANs, use the clear spantree portvlancost command.
Examples — The following command resets the STP port cost on ports 5
and 6 to the default value:
WX1200# clear spantree portcost 5-6
success: change accepted.
See Also
clear spantree portvlancost on page 533
display spantree portvlancost on page 542
set spantree portcost on page 553
set spantree portvlancost on page 556
Fast
Convergence,
cont.
set spantree backbonefast on page 550
display spantree backbonefast on page 539
set spantree uplinkfast on page 558
display spantree uplinkfast on page 548
Statistics
display spantree statistics on page 542
clear spantree statistics on page 535
Table 75 STP Commands by Usage (continued)
Type
Command