3Com WXR100 3CRWXR10095A - Manual (Page 759)

23 S
YSTEM
L
OG
C
OMMANDS
Use the system log commands to record information for monitoring and
troubleshooting. MSS system logs are based on RFC 3164, which defines
the log protocol.
Commands by
Usage This chapter present system log commands alphabetically. Use Table 120
to locate commands in this chapter based on their use.
clear log Clears the log messages stored in the log buffer, or removes the
configuration for a syslog server and stops sending log messages to that
server.
Syntax — clear log [buffer | server ip-addr]
„ buffer — Deletes the log messages stored in nonvolatile storage.
„ server ip-addr — Deletes the configuration for and stops sending
log messages to the syslog server at this IP address. Specify an address
in dotted decimal notation.
Defaults — None.
Table 120 System Log Commands by Usage
Type Command
System Logs set log on page 764
set log mark on page 767
display log buffer on page 760
display log config on page 762
display log trace on page 763
clear log on page 759