3Com WXR100 3CRWXR10095A - Manual (Page 418)

418 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
See Also
„
clear ap boot-configuration on page 358
„
display ap boot-configuration on page 390
„
set ap boot-configuration vlan on page 423
set ap boot-
configuration mesh
mode Enables WLAN mesh services on the MAP.
Syntax — set ap ap-number boot-configration mesh mode [ mode
{ enable | disable }]
„ ap ap-number
— Index value that identifies the MAP on the WX.
„ mode { enable | disable } — Enables or disables WLAN mesh services
for the MAP.
Defaults — Disabled.
Access — Enabled.
History —Introduced in MSS version 6.0.
Usage — Use this command to enable WLAN mesh services for an Mesh
AP. Prior to deploying the Mesh AP in its final untethered location, you
must connect the MAP to an WX and enter this command to configure
the MAP for mesh services.
Examples — The following command enables WLAN mesh services for
MAP 7:
WX4400# set ap 7 boot-configuration mesh mode enable
success: change accepted.
See Also
„
display ap mesh-links on page 377
„
set ap boot-configuration mesh ssid on page 421
„
set service-profile mesh on page 498