3Com WXR100 3CRWXR10095A - Manual (Page 422)

422 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
set ap boot-
configuration
switch Specifies the WX a Distributed MAP contacts and attempts to use as its
boot device.
Syntax — set ap ap-number boot-configuration switch
[switch-ip ip-addr] [name name dns ip-addr] [mode {enable |
disable }]
„ ap ap-number — Index value that identifies the MAP on the WX.
„ switch-ip ip-addr — The IP address of the WX switch the Distributed
MAP should boot from.
„ name name — The fully qualified domain name of the WX the
Distributed MAP should boot from. When both a name and a
switch-ip are specified, the MAP uses the name.
„ dns
ip-addr — The IP address of the DNS server used to resolve the
specified name of the WX switch.
„ mode { enable | disable } — Enables or disables the MAP using the
specified boot device.
Defaults — By default MAPs use the process described in “Default MAP
Boot Process”, in the
Wireless LAN Switch and Controller Configuration
Guide to boot from a WX, instead of using a manually specified WX.
Examples — Enabled.
History —Introduced in MSS 4.2. Version 6.0 removed the dap option.
Usage — When you specify a boot WX for a distributed MAP to boot
from, it boots using the process described in “MAP Boot Process Using
Static IP Configuration”, in the
Wireless LAN Switch and Controller
Configuration Guide .
When a static IP address is specified for a Distributed MAP, there is no
preconfigured DNS information or DNS name for the WX the Distributed
MAP attempts to use as its boot device. If you configure a static IP
address for a Distributed MAP, but do not specify a boot device, then the
WX must be reachable via subnet broadcast.
Examples — The following command configures Distributed MAP 1 to
use the WX with address 172.16.0.21 as its boot device.