3Com WXR100 3CRWXR10095A - Manual (Page 44)

44 N EW F EATURES S UMMARY
set radio-profile
rf-scanning
channel-scope
Configures the channel scope for RF scanning.
Syntax — set radio-profile profile-name rf-scanning
channel-scope [operating | regulatory | all]
„ profile-name — Name of the radio profile.
„ regulatory — Scans and audits regulatory channels for 802.11a or802.11b/g.
„ operating — Scans and audits the current channel.
„ all
— Scans and audits all channels on the radio
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 6.2.
Examples — To scan only operating channels on radio profile, gofish,
use the following command:
WX# set radio-profile gofish rf-scanning channel-scope
operating
success: change accepted
RF Detection
Configuration This section describes deprecated, replaced, modified, and new
rfdetect
commands for configuring RF classifications in MSS 7.0.
Deprecated Commands The following commands were deprecated as of MSS 6.2:
„ set rfdetect vendor-list [client | ap]
„ display rfdetect vendor-list
„ clear rfdetect vendor-list
„ set radio-profile profile-name countermeasures configured