3Com WXR100 3CRWXR10095A - Manual (Page 359)

clear ap radio load-balancing group 359
clear ap radio
load-balancing
group Removes a MAP radio from its load-balancing group.
Syntax clear ap ap-number radio {1 | 2} load-balancing group
„
ap ap-number — Index value that identifies the MAP on the WX.
„
radio 1 — Radio 1 of the MAP.
„
radio 2 — Radio 2 of the MAP. (This option does not apply to
single-radio models.)
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 6.0.
Usage — If an MAP radio has been assigned to an RF load balancing
group, you can use this command to remove the MAP radio from the
group.
Examples — The following command clears radio 1 on MAP 7 from the
load balancing group to which it had been assigned:
WX# clear ap 7 radio 1 load-balancing group
WX#
See Also
„
display load-balancing group on page 396
„
set ap radio load balancing on page 437
„
set load-balancing strictness on page 447
„
set ap local-switching mode on page 427