3Com WXR100 3CRWXR10095A - Manual (Page 38)

38 N EW F EATURES S UMMARY
set mac-user mac-addr attr user-name value
set usergroup group-name attr user-name value
set mac-usergroup group-name attr user-name value
where value is the username that is displayed in session information. It
can be up to 80 characters, including numbers and special characters.
To clear the configuration, use one of the following commands:
clear user username attr user-name
clear usergroup group-name attr user-name
clear mac-usergroup group-name attr user-name
If configured, usernames are now part of
display
output such as
display sessions :
WX# display sessions
Since the session user name is replaced by the user-name attribute, the
display sessions
output displays this attribute as the user name for
the session. When the attribute is obtained from a user group, the user
name of all users in the group appears the same and you cannot
differentiate between them. However, the MAC address is added to the
user group name in the output.
Enhancements to
Location Policy
Configuration MSS Version 7.0 adds a
time-of-day
attribute to the following
command for controlling wireless access during certain times of day:
set location policy {deny | permit} if [time-of-day operator
time-of-day]
„ operator
„ eq - Defines a specific timeframe
„ neq
- Defines any time other than a specific timeframe
„ time-of-day
User
Name
-----------------
Sess
ID
------------
IP or MAC
Address
----------------------
VLAN
Name
------
Port/
Radio
------
engineering-05:0c:78 28* 10.7.255.2 yellow 5/1
engineering-79:86:73 29* 10.7.254.3 red 2/1
engineering-1a:68:78 30* 10.7.254.8 red 7/1
engineering-45:12:34 35* 10.9.254.7 blue 2/1