3Com WXR100 3CRWXR10095A - Manual (Page 576)

576 C HAPTER 13: IGMP S NOOPING C OMMANDS
set igmp mrsol Enables or disables multicast router solicitation by a WX.
Syntax —
set igmp mrsol {enable | disable} [vlan vlan-id]
„ enable
— Enables multicast router solicitation.
„ disable — Disables multicast router solicitation.
„ vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, multicast router solicitation is disabled or enabled on all VLANs.
Defaults — Multicast router solicitation is disabled on all VLANs by
default.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Examples — The following command enables multicast router
solicitation on VLAN orange:
WX1200# set igmp mrsol enable vlan orange
success: change accepted
See Also
„
set igmp mrsol mrsi on page 576
set igmp mrsol mrsi Changes the interval between multicast router solicitations by a WX on
one VLAN or all VLANs.
Syntax — set igmp mrsol mrsi seconds [vlan vlan-id]
„ seconds — Number of seconds between multicast router solicitations.
You can specify a value from 1 through 65,535.
„ vlan vlan-id — VLAN name or number. If you do not specify a
VLAN, MSS changes the multicast router solicitation interval for all
VLANs.
Defaults — The interval between multicast router solicitations is 30
seconds by default.
Access — Enabled.
History — Introduced in MSS Version 3.0.