3Com WXR100 3CRWXR10095A - Manual (Page 43)

RF Scanning Enhancements 43
success: change accepted
RF Scanning
Enhancements A new attribute,
sentry
, is now available to independently configure and
control scanning behaviors on radios. For example, a disabled radio does
not transmit or receive, and a radio that is scanning, but not providing
radio service to clients, is in sentry mode.
sentry allows longer dwell
times on scanning channels than the
enable
mode. This attribute has
been added to the following commands:
set ap apnum radio [1 | 2] mode [enable | sentry | disable]
set radio-profile profile-name mode [enable | sentry |
disable]
The remainder of this section describes commands used to configure RF
scanning.
set radio-profile
rf-scanning mode
Configures RF scanning on radios running MSS 7.0.
Syntax —
set radio-profile profile-name rf-scanning mode
[passive | active]
„ profile-name — Name of the radio profile.
„ passive
— The radio scans once per predefined time and audits the packets on
the wireless network. The default time is 1 second.
„ active — The radio actively sends probes to other channels and then audits the
packets on the wireless network.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 6.2.
Examples — To configure active rf-scanning mode for radio profile
gofish, use the following command:
WX# set radio-profile gofish rf-scanning mode active
success: change accepted