3Com WXR100 3CRWXR10095A - Manual (Page 723)

display config 723
Table 115 describes the fields in the display boot output.
See Also
„
display version on page 725
„
reset system on page 731
„
set boot configuration-file on page 735
display config Displays the configuration running on the WX.
Syntax — display config [area area] [all]
„ area area
— Configuration area. You can specify one of the
following:
„ aaa
„ acls
„ ap
„ arp
„ eapol
„ httpd
„ ip
Table 115 Output for display boot
Field Description
Configured boot
version Software version the switch will run next time the software is
rebooted.
Configured boot
image Boot partition and image filename MSS will use to boot next
time the software is rebooted.
Configured boot
configuration Configuration filename MSS will use to boot next time the
software is rebooted.
Backup boot
configuration The name of the configuration file to be used in the event
that MSS cannot read the configured boot configuration file
next time the software is rebooted.
Booted version Software version the switch is running.
Booted image Boot partition and image filename MSS used the last time
the software was rebooted. MSS is running this software
image.
Booted configuration Configuration filename MSS used to load the configuration
the last time the software was rebooted.