3Com WXR100 3CRWXR10095A - Manual (Page 531)

12 STP C
OMMANDS
Use Spanning Tree Protocol (STP) commands to configure and manage
spanning trees on the virtual LANs (VLANs) configured on a wireless LAN
switch or controller, to maintain a loop-free network.
STP Commands by
Usage This chapter presents STP commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 75 STP Commands by Usage
Type Command
STP State set spantree on page 549
display spantree on page 536
display spantree blockedports on page 540
Bridge Priority set spantree priority on page 558
Port Cost set spantree portcost on page 553
set spantree portvlancost on page 556
display spantree portvlancost on page 542
clear spantree portcost on page 532
clear spantree portvlancost on page 533
Port Priority set spantree portpri on page 555
set spantree portvlanpri on page 557
clear spantree portpri on page 533
clear spantree portvlanpri on page 534
Timers set spantree fwddelay on page 551
set spantree hello on page 551
set spantree maxage on page 552
Fast Convergence set spantree portfast on page 554
display spantree portfast on page 541