3Com WXR100 3CRWXR10095A - Manual (Page 291)

set authentication dot1x 291
„
set authentication admin on page 287
„
set authentication dot1x on page 291
„
set authentication mac on page 295
„
set authentication mac on page 295
„
set authentication web on page 302
set authentication
dot1x Configures authentication and defines how it is performed for specified
wireless or wired authentication clients who use an IEEE 802.1X
authentication protocol to access the network through the WX.
Syntax — set authentication dot1x {ssid ssid-name | wired}
user-glob [bonded] protocol method1 [method2] [method3]
[method4]
„ ssid ssid-name — SSID name to which this authentication rule
applies. To apply the rule to all SSIDs, type any.
„ wired — Applies this authentication rule specifically to users
connected to a wired authentication port.
„ user-glob
— A single user or a set of users with 802.1X network
access.
Specify a username, use the double-asterisk wildcard character (**) to
specify all usernames, or use the single-asterisk wildcard character (*)
to specify a set of usernames up to or following the first delimiter
character — either an at sign (@) or a period (.). (For details, see “User
Globs” on page 78.)
„ bonded — Enables Bonded Auth™ (bonded authentication). When
this feature is enabled, MSS authenticates the user only if the
computer the user is on has already been authenticated.
„ protocol — Protocol used for authentication. Specify one of the
following:
„ eap-md5 — Extensible Authentication Protocol (EAP) with
message-digest algorithm 5. For wired authentication clients:
Uses challenge-response to compare hashes
Provides no encryption or integrity checking for the connection
„ eap-tls — EAP with Transport Layer Security (TLS):