3Com WXR100 3CRWXR10095A - Manual (Page 394)

394 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
Examples — The following command displays configuration information
for all the Distributed MAPs configured on a WX switch:
WX4400# display ap global
Total number of entries: 8
AP Serial Id WX IP Address Bias
--- ----------- --------------- ----
1 M9DE48B012F00 10.3.8.111 HIGH
- M9DE48B012F00 10.4.3.2 LOW
2 M9DE48B123400 10.3.8.111 LOW
- M9DE48B123400 10.4.3.2 HIGH
17 M9DE48B123600 10.3.8.111 HIGH
- M9DE48B123600 10.4.3.2 LOW
18 M9DE48B123700 10.3.8.111 LOW
- M9DE48B123700 10.4.3.2 HIGH
Table 67 describes the fields in this display.
See Also
„
display ap config on page 364
„
display ap connection on page 391
„
display ap unconfigured on page 395
„
set ap on page 135
„
set ap bias on page 415
Table 67 Output for display ap global
Field Description
AP ID assigned to the Distributed MAP.
Note: AP numbers are listed only for Distributed MAPs
configured on this WX switch. If the field contains a
hyphen ( - ), the Distributed MAP configuration displayed in
the row of output is on another WX switch.
Serial Id Serial ID of the Distributed MAP.
WX IP Address System IP address of the WX switch on which the Distributed
MAP is configured. A separate row of output is displayed for
each WX switch on which the Distributed MAP is configured.
Bias Bias of the WX switch for the MAP:
„
High
„
Low