3Com WXR100 3CRWXR10095A - Manual (Page 429)

set ap name 429
Examples — The following command specifies that MAP 7 use VLAN
profile locals:
WX# set ap 7 local-switching vlan-profile locals
success: change accepted.
See Also
„
clear ap local-switching vlan-profile on page 355
„
set ap local-switching mode on page 427
„
set vlan profile on page 175
set ap name Changes a MAP name.
Syntax — set ap ap number name name
„ ap ap-number — Index value that identifies the MAP on the WX.
„ name
— Alphanumeric string of up to 16 characters, with no spaces.
Defaults — The default name of a directly attached MAP is based on the
port number of the MAP access port attached to the MAP. For example,
the default name for a MAP on MAP access port 1 is MAP01.
Access — Enabled.
History —Introduced in MSS Version 3.0. Default Distributed MAP name
changed from DMPnum to DAPnum in MSS Version 4.1. Version 6.0
removed the dap option.
Examples — The following command changes the name of the MAP on
port 1 to techpubs:
WX1200# set ap 1 name techpubs
success: change accepted.
See Also
„
display ap config on page 364