3Com WXR100 3CRWXR10095A - Manual (Page 555)

set spantree portpri 555
set spantree portpri Changes the STP priority of a network port or ports for selection as part
of the path to the STP root bridge in the default VLAN on a wireless LAN
switch.
Syntax —
set spantree portpri port-list priority value
„ port-list
— List of ports. MSS changes the priority on the specified
ports.
„ priority value
— Priority value. You can specify a value from 0
(highest priority) through 255 (lowest priority).
Defaults — The default STP priority for all network ports is 128.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command applies only to the default VLAN (VLAN 1). To
change the priority of a port in another VLAN, use the set spantree
portvlanpri command.
Examples — The following command sets the priority of ports 3 and 4 to
48:
WX1200# set spantree portpri 3-4 priority 48
success: change accepted.
See Also
„
clear spantree portpri on page 533
„
clear spantree portvlanpri on page 534
„
display spantree on page 536
„
set spantree portvlanpri on page 557