3Com WXR100 3CRWXR10095A - Manual (Page 504)

504 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
set service-profile
shared-key-auth Enables shared-key authentication, in a service profile.
Use this command only if advised to do so by 3Com. This command does
not enable preshared key (PSK) authentication for Wi-Fi Protected Access
(WPA). To enable PSK encryption for WPA, use the
set service-profile auth-psk command.
Syntax —
set service-profile name shared-key-auth {enable |
disable }
„ name — Service profile name.
„ enable
— Enables shared-key authentication.
„ disable — Disables shared-key authentication.
Defaults — Shared-key authentication is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Examples — The following command enables shared-key authentication
in service profile sp4:
WX4400# set service-profile sp4 shared-key-auth enable
success: change accepted.
See Also
„
display radio-profile on page 398
„
set radio-profile mode on page 464
„
set service-profile cipher-tkip on page 489
set service-profile
short-retry-count Changes the short retry threshold for a service profile. The short retry
threshold specifies the number of times a radio can send a short unicast
frame without receiving an acknowledgment. A short unicast frame is a
frame that is shorter than the frag-threshold.
Syntax — set service-profile name short-retry-count
threshold
„ name — Service profile name.