3Com WXR100 3CRWXR10095A - Manual (Page 747)

22 S
NOOP
C
OMMANDS
Use snoop commands to monitor wireless traffic, by using a MAP as a
sniffing device. The MAP copies the sniffed 802.11 packets and sends the
copies to an observer, which is typically a protocol analyzer such as
Ethereal or Tethereal.
(For more information, including setup instructions for the monitoring
station, see the “Remotely Monitoring Traffic” section in the
“Troubleshooting a WX Switch” chapter of the
Wireless LAN Switch and
Controller Configuration Guide .)
Commands by
Usage This chapter presents snoop commands alphabetically. Use the following
table to locate commands in this chapter based on their use.
Table 118 Remote Monitoring (Snooping) Commands By Usage
Remote
monitoring
(snooping) set snoop on page 749
display snoop info on page 754
display snoop stats on page 756
clear snoop on page 748
set snoop map on page 752
display snoop map on page 755
display snoop on page 754
clear snoop map on page 748
set snoop mode on page 753
display snoop stats on page 756