3Com WXR100 3CRWXR10095A - Manual (Page 410)

410 C HAPTER 11: M ANAGED A CCESS P OINT C OMMANDS
reset ap Restarts a MAP access point.
Syntax —
reset ap ap-number
„ ap ap-number
— Index value that identifies the MAP on the WX.
„ dap dap-num — Number of a Distributed MAP to reset.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0. Version 6.0 removed the dap
option.
Usage — When you enter this command, the MAP drops all sessions and
reboots.
CAUTION: Restarting a MAP can cause data loss for users who are
currently associated with the MAP.
Examples — The following command resets MAP 7:
WX1200# reset ap 7
This will reset specified AP devices.
Would you like to continue? (y/n)y
success: rebooting ap attached to port 7
set ap auto Creates a profile for automatic configuration of MAPs.
Syntax —
set ap auto
Defaults — None.
Access — Enabled.
History — Introduced in MSS 4.0. Version 6.0 removed the dap option.
Usage — Table 72 lists the configurable profile parameters and their
defaults. The only parameter that requires configuration is the profile
mode. The profile is disabled by default. To use the profile to configure
Distributed MAPs, you must enable the profile using the set ap auto
mode enable command.